Remove the wheel and remove the valve core and cap. To remove an old sensor and install a new one, follow these steps:ġ. This switch initializes the warning system after certain repair procedures. To address the differences in the air pressure settings by tire type, a tire pressure warning reset switch is used. When the value is less than the standard value registered in the ECU, the warning light on the instrument cluster turns on. If the transmitter ID has been registered, the ECU compares the measured air pressure value with the standard value. These waves are then sent to the tire pressure ECU from the tire pressure monitor receiver. The sensor sends tire pressure data to the tire pressure receiver assembly as radio waves. The Toyota Tundra’s tire pressure monitoring system (TPMS) contains a valve sub-assembly that consists of a tire pressure sensor and a transmitter, both of which are installed in each tire and wheel assembly. SPECIAL TOOLS NEEDED? Yes (Techstream tool).
0 kommentar(er)
